Link-type servo sprayer (atomizer)

Main characteristics：

——

1. Adopt linkage structure, driven by RV reducer for robot, high mechanical strength, good stability and long service life.

2. It adopts Japan YASKAWA servo motor and Japan NTN/NSK bearing.

3. It can standby before opening the mold selection, shorten the spray down time, effectively save the spray cycle.

4. Electric mold thickness adjustment function, saving time, energy and safety.

5. Multiple sets of mold spraying programs can be stored, and the stored programs can be used directly when replacing the molds by calling them directly in the man-machine interface, which makes the operation and maintenance very convenient.

6. The control box is reserved for signals, which can be operated semi-automatically with the die-casting machine, or connected with the die-casting machine, taking out machine, etc., to become a fully automated equipment.

7. Adopting touch screen of man-machine interface, it is convenient to adjust and set various parameters, and it has the function of troubleshooting and displaying, which is convenient for troubleshooting and maintenance in the later stage.

8. Equipped with nozzle type spray nozzle group, good atomization effect, easy to replace and install. With fixed-point spraying, circulating spraying and floating spraying.

9. Movable and fixed mold can blow at the same time, also movable and fixed mold can be controlled separately. No blowing under spraying state, no spraying under blowing state. There is a rising blowing function, can be in the spray work is completed at the same time as the nozzle rising blowing to clean the mold surface of the dirt, so that the mold surface to keep clean.

The nozzle group is shown in the following schematic diagram (movable and fixed molds are controlled separately according to left, center and right):

WTSYPD-2# is equipped with the following nozzle set schematic diagram:

WTSYPD-3# is equipped with the following nozzle set schematic diagram:

WTSYPD-4# is equipped with the following nozzle set schematic diagram:

11. The above nozzles are controlled by the skin bag (air control water), which can precisely control the flow rate to meet the spraying needs of different products and different locations. Pouch control is the most convenient and cost effective way to maintain and clean the equipment. The use of external mixing spraying, spraying each die after the end of the spraying at the nozzle can be realized to close the spray, greatly reducing the amount of mold release agent, reducing the residue, improve the production environment of the die casting car. Each nozzle in the spraying interval are continuously spraying air, accelerate the evaporation of water, and at the same time to prevent the nozzle dripping, reduce the moisture residue; spraying is over, there is an independent set pressure strong jet circuit, and further blow away the moisture and impurities.

Main parameters：

——